Block IP or Website using PowerShell
While blocking IP ranges work perfectly, blocking a website or domain is tricky. That’s because there can be a multiple IP attached to the domain, and while you can prevent them, the DNS resolver can figure out a different IP every time it queries. Also, at times, the same IP could be used by related services, and blocking that IP would mean blocking other services as well. You will need admin privileges to execute these.
1] Block IP or Range using PowerShell
Using this command, you can use a single IP address or range of IP addresses. Execute the following command in PowerShell. New-NetFirewallRule -DisplayName “Block XYZ.com IP address” -Direction Outbound –LocalPort Any -Protocol TCP -Action Block -RemoteAddress 146.185.220.0/23 You can replace Block XYZ.com IP address with anything you can remember or makes it easy to understand whenever you look back at it. The IP address mentioned at the end of the RemoteAddress option is what will be blocked. Any website or service that resolves to that will be blocked. You can replace the RemoteAddress option with the LocalAddress option if the IP is the local network IP address.
Once the execution is complete, you should receive a status message as ” The rule was parsed successfully from the store. (65536)”. Open Windows Firewall and check if the entry is available. Once confirmed, you should be able to add more using PowerShell.
2] Block Website or Domain using PowerShell
Since the function doesn’t support URL blocking, we have two choices. First is to query all possible IP of that domain, and block them. The second is to find known official IP ranges and block them. The later has lower chances of accidentally blocking other services compared to the former. That said, if blocking a domain is essential, you can always use another software to block them. Resolve-DnsName “facebook.com” Note the IP address which we will use in the second method New-NetFirewallRule -DisplayName “Block XYZ.com IP address” -Direction Outbound –LocalPort Any -Protocol TCP -Action Block -RemoteAddress 146.185.220.0/23 When I used this with YouTube, it did not work though direct IP was blocked. When I used it with Facebook, it worked. So if a website can be resolved using multiple IP addresses, then this method will not work. Using PowerShell commands are straightforward. If you ever used the command prompt, it is as good as that; I hope you were able to block IP or a website using PowerShell in Windows successfully. Anytime you want to remove them, you can do so from Windows Firewall or use the Remove-NetFirewallRule command.
